User's Manual

Ubee Interactive — www.ubeeinteractive.com
4 Ubee UBC1307-CA00 – Safety and Installation Product Insert v1.1
Installation
To install this device, follow the procedures
below and refer to the following page for a
connection diagram.
1. Connect one end of a coaxial cable (not
included) to the CABLE port on the device.
Connect the other end to a cable splitter or
the cable wall outlet. Be sure not to bend or
over tighten the cables as this may strain
the connector and cause damage. If you
plan to connect the device and a television
to the same cable wall outlet, you must use
a cable line splitter (not included).
2. Connect one end of the supplied Ethernet
cable to one of the LAN ports (LAN1 to
LAN4) on the device. Connect the other
end to the ETHERNET port (ETH1 to ETH4)
on a PC. Note: Category 5e or Category 6
Ethernet cables with RJ45 connectors must
be used when connecting Ethernet devices
to the LAN ports. This ensures Gigabit
Ethernet speeds (unless the computer
does not support it).
3. Connect one end of an RJ11 phone cable
to one of the TEL ports (TEL1 to TEL2) on
the device (a port that has been
provisioned for voice service as specified
by the service provider). Connect the other
end to the phone port of the telephone.
Note: If voice service is not provisioned
through the service provider, telephone
service is not available.
4. Connect the power adapter to the POWER
port on the device. Plug the other end of
the power adapter into the AC wall outlet.
Important: Use only the power adapter
that is shipped with the device.