User's Manual

Ubee Interactive — www.ubeeinteractive.com
6 Ubee DVW32H – Safety and Installation Product Insert v1.1
Additional Information
1. RESET Button: To reset the device to
factory defaults. Using a pointed object,
insert it into the button opening, and hold
for more than 10 seconds. The device will
reset and reboot. Note: Not all parameters
are reset to factory defaults. Refer to the
User Guide for more information.
2. WPS button: The WPS button located on
the front of the Device, The Wi-Fi Protected
Setup method used to connect a PIN
protected Wi-Fi device to this Device.
LEDs and Other Device Indicators
See the following diagram and descriptions of the
device’s LED behavior, and the behavior of the
back-panel Ethernet indicators.
LED Indicators (Color = Green When On):
POWER/ READY—(POWER, Green) If On,
indicates that the device has successfully
completed internal power-on tests. LED flashes if
power-on fails. (READY, Blue) When the device
is obtaining an IP address and configuration file,
the LED flashes. When successfully complete,
the LED is On.
DS/US—LED flashes once every second while
scanning downstream, once locked, flashes
twice every second while scanning upstream,
solid when online. When the device performs a
firmware upgrade, the LED flashes. When
channel bonding, LED should be Blue otherwise
green.
Tel 1/Tel 2—The LED is On when a telephone is
on-hook. The LED flashes when a telephone is
off-hook.
Wi-Fi—The LED is on (Solid Green) when
enabled and blinking (green) when data is been
passed between the Device and the connected