User's Manual

Ubee Interactive — www.ubeeinteractive.com
7 Ubee DVW32E – Safety and Installation Product Insert v1.0
Green - one channel bonded.
Blue - more than one channel bonded.
READY—When the device is obtaining an IP
address and configuration file, the LED flashes.
When successfully complete, the LED is On.
Tel 1/Tel 2—The LED is On when a telephone is
on-hook. The LED flashes when a telephone is
off-hook.
Wi-Fi—The LED is on (Solid Green) when
enabled and blinking (green) when data is been
passed between the Device and the connected
laptop, computer, etc.
WPS LED— When a user pushes the WPS
button or triggers WPS via the device’s web GUI,
this LED on the front of the device flashes Green
for 2 minutes until a PIN is entered from a
wireless client wishing to connect (e.g. a laptop
computer). After a Wi-Fi client attaches
successfully, the LED remains On (green) for 5
minutes, then turns Off.
LAN1/LAN2—The Ethernet ports are used to
connect Ethernet devices, such as computers,
gaming consoles, and/or routers/hubs to the
Device using RJ45 cables. Each Ethernet port
has an LED to indicate their statuses when an
Ethernet device is connected.
When an Ethernet device, is connected to the
cable modem, the LED is Green when connected
at 10/100 Mbps speeds. The LED is Blue when
connected at 1000 (Gigabit Ethernet) speed.
When data is being passed between the Device
and the connected laptop, computer, etc, the
LED flashes with same color scheme (i.e. green
for 10/100Mbps or blue for Gigabit).