User's Manual

Ubee Interactive — www.ubeeinteractive.com
6 Ubee DVW32E – Safety and Installation Product Insert v1.0
Additional Information
1. RESET Button: To reset the device to
factory defaults. Using a pointed object,
insert it into the button opening, and hold
for more than 10 seconds. The device will
reset and reboot. Note: Not all parameters
are reset to factory defaults. Refer to the
User Guide for more information.
2. WPS button: The WPS button located on
the front of the Device, The Wi-Fi Protected
Setup method used to connect a PIN
protected Wi-Fi device to this Device.
LEDs and Other Device Indicators
See the following diagram and descriptions of the
device’s LED behavior, and the behavior of the
back-panel Ethernet indicators.
LED Indicators (Color = Green When On):
Power—If On, indicates that the device has
successfully completed internal power-on tests.
LED flashes if power-on fails.
DS — LED blinks during firmware upgrade
When the device initializes, the LED flashes.
When the device locks on the downstream (DS)
channels and registers OK, the LED is On. If
unable to register or lock, the LED flashes.
Green - one channel bonded.
Blue - more than one channel bonded.
US — LED blinks during firmware upgrade.
When the device initializes, the LED flashes.
When the device locks on the upstream (US)
channels and registers OK, the LED is On. If
unable to register or lock, the LED flashes.