User's Manual

Ubee Interactive — www.ubeeinteractive.com
6 Ubee DVW32D – Safety and Installation Product Insert v1.0
Additional Information
1. RESET Button To reset the device to
factory defaults. Using a pointed object,
insert it into the button opening, and hold
for more than 10 seconds. The device will
reset and reboot. Note: Not all parameters
are reset to factory defaults. Refer to the
User Guide for more information.
2. WPS button: The WPS button located on
the front of the Device, The Wi-Fi Protected
Setup method used to connect a PIN
protected Wi-Fi device to this Device.
LEDs and Other Device Indicators
See the following diagram and descriptions of the
device’s LED behavior, and the behavior of the
back-panel Ethernet indicators.
LED Indicators (Color = Green When On):
Power—If On, indicates that the device has
successfully completed internal power-on tests.
LED flashes if power-on fails.
DS/US—DS/US LED behavior, flashes once
every second while scanning downstream, once
locked, flashes twice every second while
scanning upstream, solid when online. For
firmware upgrade, flashes while POWER and
READY LED’s are on solid. – This was
implemented for COX. When channel bonding,
LED should be Blue otherwise green
READY—When the device is obtaining an IP
address and configuration file, the LED flashes.
When successfully complete, the LED is On.
Tel 1/Tel 2—The LED is On when a telephone is
on-hook. The LED flashes when a telephone is
off-hook.
Wi-Fi—The LED is on (Solid Green) when
enabled and blinking (green) when data is been