User's Manual

4
4. Connect the power adapter to the POWER port
on the device. Plug the other end of the power
adapter into the AC wall outlet. Important: Use
only the power adapter that is shipped with the
device.
◆ Additional Rear Panel Buttons
• RESET button: To reset the device to the factory
defaults, insert a small object into the small, reset
opening and hold for more than 10 seconds. The
device resets to factory defaults and reboots.
Note: Not all parameters are reset to factory
defaults. Refer to the user guide for more
information.
• USB Ports: One USB port with host controller is
available.
• WPS (on the side of the device): The Wi-Fi
Protected Setup (WPS) method used to connect
PIN-protected Wi-Fi equipment to this device.
◆ LEDs on Front Panel
The following table describes LED behavior.
LED COLOR DESCRIPTION
PWR
Green
LED remains on when device
has completed internal power‐on
tests successfully. LED blinks if
power‐on test fails.
DS
Green
Blue
LED blinks during firmware
upgrade. LED is on when device
has locked to downstream
channel.
• Green - one channel bonded.
LED COLOR DESCRIPTION
•
Blue - more than one channel
bonded.
US
Green
Blue
LED blinks during firmware
upgrade. LED is on when device
has locked to upstream channel.
• Green - one channel bonded.
• Blue - more than one channel
bonded.
RDY
Green
LED blinks when obtaining IP
address and configuration file
and remains on when
successful.
Tel1/Tel2
Green
LED is on when telephone is on-
hook. LED blinks when
telephone is off-hook and during
firmware upgrade.
WLAN
Green
LED is on when connected and
blinks when traffic is passed.
WPS
Green
LED blinks for 4 minutes after
WPS button is pushed until PIN
is entered from a wireless client.
LED remains on for 5 minutes
when client is connected, and
then turns off.
ETH1 –
ETH4
Green
Blue
LED is on with connectivity
between Ethernet port on the
device and Ethernet port on the
PC. LED blinks when traffic is
passed.
• Green indicates 10/100
Ethernet connection.
• Blue indicates 1000 Ethernet
connection.
USB
Green
LED is green when a USB
device is connected and blinks
when data is passed.