User's Manual

3
◆ Additional Rear Panel Buttons
• RESET button: Resets the device to the
factory defaults. To reset, insert a small
object into the reset opening and hold for
more than 10 seconds. The device resets to
factory defaults and reboots. Note: Not all
parameters are reset to factory defaults.
Refer to the user guide for more information.
• USB Port: Provides one USB port with host
controller.
• WPS (on top of the device): Provides the Wi-
Fi Protected Setup (WPS) method used to
connect PIN-protected Wi-Fi equipment to
this device.
◆ LEDs on Front Panel
The following table describes LED behavior. LEDs are
white.
LED DESCRIPTION
Power
On when device has completed internal
power‐on tests successfully. Blinks if
power‐on test fails.
US/DS
Upstream/downstream connectivity. Blinks
when ranging is in process, On when
ranging is complete. Off when scanning for
DS channel.
Online
On when device is online. Blinks when
obtaining IP address and configuration file.
Off when device is offline.
WiFi
On when Wi-Fi is enabled. Blinks when
traffic is passed. Off when Wi-Fi is
disabled.
Figure 2 – Front Panel