User's Manual

2
Grounding of the Outer Conductive Shield of a
Coaxial Cable.
◆ Installation Instructions
Use the following guidelines to install the device. Place
the device near an outlet so the power supply can be
plugged in directly to the wall outlet without an extension.
Observe the maximum load of the electrical outlet. Use
the power supply provided with the device.
To install the device:
Connect the device according to the following
instructions and Figure 1.
1. Connect one end of the RF coaxial cable (not
included) to the RF port on the device. Connect the
other end to the cable wall outlet or a cable splitter.
(Use a cable splitter, not included, to connect the
device and a television to the same cable wall outlet.)
Be sure not to bend or over tighten the cables as this
may strain the connector and cause damage.
Figure 1 – Connection Diagram
2. Connect one end of the Ethernet cable (included) to
one of the Ethernet ports (ETH1 – ETH4) on the
device. Connect the other end to the Ethernet port on
a PC. Note: Use Category 5e or 6 cables with RJ45
connectors when connecting Ethernet devices to the
LAN ports. This ensures Gigabit Ethernet speeds
when the computer supports it.
3. Connect the power supply to the POWER port on the
device. Plug the other end of the power supply into
the AC wall outlet. Important: Use only the power
supply provided with this device.