Phau Ntawv Qhia

MV-1533-01-2022

2.3 Fitting the skimmer

To t the skimmer, repeat the procedure to mark the skimmer hole (see below). The skimmer set

may contain either 2 x single gaskets or one double gasket. Fit the double gasket (4) around the

skimmer perimeter and the hole in the lining so that the gasket seals both the pool wall and the li-

ner. Fit single gaskets one on each side, i.e. one on the outside of the liner and one on the outside

of the pool wall.

Single gasket

A tip to help you t single gaskets:

• Push a screw through the upper holes on the right and left of the front skimmer frame and the

gasket on the inside of the pool.

• The position of the two screw holes is now marked on the inside of the liner by the two screws

inserted in the front skimmer frame (3).

• Prick a hole in the liner to mark these two positions.

• Now t the front frame and skimmer gasket to the inside of the pool.

NB: Both screws must be inserted from the inside and out through the pool wall.

Fit the other skimmer gasket onto the screws on the outside.