Installation Guide

Host WiFi Network Extended NetworkHalfway
Router Clients
Extender
Red Flash: Connecting / not connected to host Wi-Fi
Solid Red: Connected, signal is weak
Solid Purple: Connected, signal is fair
Solid Blue: Connected, signal is strong
— 5 — — 6 —
2. Then below window will pop up, Use admin for password to
log in.
Note: If the login window does not appear,Launch a web browser, and
enter http://cudyre.net/ or http://192.168.10.254/ in the address bar. Use
admin for password to log in. If still not work, please refer to FAQ > Q1.
http://cudyre.net/
Select Wireless Extender,then click Next.
Mode Host Network Extended Network Summary
Exit
Next
Wireless ExtenderOpertion Mode
Access Point
43
2
1
Log In
Auto
Password
3. Follow the step by step configuration to the end. After
configuration, below page would pop up.Then wait the LED
turns solid ON, it may take 1 or 2 minutes.
XXXXXXXX-EXT2G
XXXXXXXX
XXXXXXXX-EXT5G
XXXXXXXX
Please connect to the new network.
xxxx-xx
WLAN
xxxx-xx
XXXXXXXX-EXT2G
XXXXXXXX-EXT5G
Note: Please check the information on the screen and confirm that the password
is the same as the wifi password of the router. Otherwise, the extender will not be
able to connect to the router WiFi.
4. Relocate the extender halfway between your router and the
WiFi dead zone, find a good place to plug it according to the
LED.