Manual

Wire Extension Kit

Installation Guide

For Models 9910APV & 1010APV

Installation of the Wire Extension Kit

US Sunlight Corp. 5625-B Brisa Street, Livermore, CA 94550 1-866-446-0966

www.ussunlight.com

Step 1: Connect the female

connectors of the Wire Extension

kit directly to the fan motor as

described in the APV installation

instructions (fig. 1).

Step 2: Insert the male connectors

from the Wire Extension Kit into the

female connectors at the end of

the solar panel wire (fig. 2)

Step 4: Place the black wire

connection into the remaining

opening in the protective casing

(fig. 4).

Step 5: Press the casing down

over the black wire and snap shut

(fig. 5).

Step 3: Slide the red wire connection

into one of the protective casings (fig.

3). Press the casing down over the

red wire firmly and snap shut (fig. 5).

Step 6: The wire extension

connection is now secure and

weather-proof (fig. 6).

The Wire Extension Kit provides up to 30 feet of additional wiring for remote-mounting your solar panel

on a roof top, wall, or fascia board. Up to two Wire Kits (60 feet) can be added to a panel (which

already includes 30 feet of wire), for a maximum of 90 feet between the panel and the fan.

Note: Do not add more than two Wire Kits, or exceed 90 feet total distance between the Panel and the

Fan, the result could be reduced performance.

fig. 1 fig. 2 fig. 3

fig. 4 fig. 5 fig. 6

PAGE 1
Wire Extension Kit Installation Guide For Models 9910APV & 1010APV The Wire Extension Kit provides up to 30 feet of additional wiring for remote-mounting your solar panel on a roof top, wall, or fascia board. Up to two Wire Kits (60 feet) can be added to a panel (which already includes 30 feet of wire), for a maximum of 90 feet between the panel and the fan. Note: Do not add more than two Wire Kits, or exceed 90 feet total distance between the Panel and the Fan, the result could be reduced performance.