Technical data

PD_OpManPS-4_05_us.fm
ELAU AG PacDrive PS-4 / PD-8 page 29
5.5 Cleaning
Hard-copy for correction
 Insert the SERCOS in/out cable in the corresponding cable duct,
snap the connector into the outlet and fix the strain relief on the
cable duct while the cable is relieved
.
 Insert the SCL connections in the corresponding cable duct,
snap the connector into the outlet and fix the strain relief on the
cable duct while the cable is relieved
.
Exchanging cables
 Open main switch.
 Lock out main switch.
DANGER!
High voltage!
Life hazard!
 Disconnect and connect power supply only when the plant is
voltage-free!
 Do not insert the connectors unless both sides are dry and
clean!
 If no ready made ELAU cables are used, make sure the
assignment of the new cables matches the wiring diagram of the
machine manufacturer!
 Remove cables from the PS-4 / fix them back (see Exchanging
PacDrive PS-4).
 Remove cables from the PD-8 / fix them back (see Exchanging
PacDrive PD-8).
 When exchanging cables, also observe the instructions of the
machine manufacturer.
5.5 Cleaning
If installed as directed, the units are to a large extent maintenance-
free.
To remove dust and foreign objects brought in by the cooling air
flow, disconnect the units from the power supply, remove them and
use dry compressed air (max. 1 bar) to blow away the pollution.