Specifications

19
Data Plus 2
• press Select (Right) button until the desired Rate appears.
• press Advance (Left) button to accept the setting displayed, and either -
• revert to Surface Mode (this setting changed)
• advance to Set: Unit (this setting not changed)
TO SET: UNITS OF MEASURE
• press BOTH buttons simultaneously, while in Surface Mode
• press Advance (Left) button 8 times
• the Units of Measure icons appear flashing (Fig. 19)
• press Select (Right) button to toggle between 'Imperial' (FT/°F) and
'Metric' (M/°C)
• press Advance (Left) button to accept the setting displayed, and either -
• revert to Surface Mode (this setting changed)
• advance to Set: FO2 Default (this setting not changed)
TO SET: FO2 50% DEFAULT ON/OFF
'Off' - FO2 value set point remains at % set
'On' - FO2 value set point reverts to 50% after dives
(The FO2 Default feature is described on page 25.)
Fig. 19 - Set Units
FT
FT
N
O
D
E
C
O
C
.
Z
.
D
E
C
O
C
.
Z
.
O
2