User's Manual

Figure 5.

sponding sockets and receive the wear rather than the permanent

socket. When worn so that satisfactory contact can no longer be

made, the test adapters can be replaced without disconnecting

the leads from their respective test socket.

15. Preliminary Starting Procedure

a. Check the voltage and frequency of the alternating current

(ac) power source to be used for the operation of Test Set, Elec-

tron Tube TV-2(*)/U. The voltage must be between 103.5 and

126.5 volts ac and the frequency between 50 and 1,000 cycles per

second (cps).

Cution: Never connect the TV-2(*)/U to a direct current (dc)

power source.

b. Release the latches and raise the cover of the tube tester.

c. Remove the power cord plug from the dummy power cord