User's Manual

CHAPTER 5

SHIPMENT, LIMITED STORAGE, AND DEMOLITION

TO PREVENT ENEMY USE

Section I. SHIPMENT

46. Disassembly of Equipment

a. Operate all switches and

AND LIMITED STORAGE

their controls to their safety posi-

tions (par. 15d) and disconnect the tube tester from the ac power

supply.

b. Remove the power cord plug from the ac source.

c. Wind the power cord around the brackets on the front panel

and insert the plug into the dummy power cord receptacle that

is mounted on the front panel.

d. Close the case and latch it securely.

47. Repackaging for Shipment or Limited Storage

(fig. 11)

The exact procedure for repackaging depends on the material

available and the conditions under which the equipment is to be

shipped or stored. Adapt the procedures outlined below whenever

circumstances permit. The information concerning the original

packaging (pars. 8 and 9) will also be helpful.

a. Material Requirements. The following materials are required

for packaging the tube tester.

For stock numbers of materials,

consult SB 38-100.

Material

Quantity

Waterproof wrapping paper ---------------------------------

Fiberboard, corrugated, single-face (flexible) ------------------

Tape, pressure-sensitive adhesive, waterproof (3-inch) ---------------

Tape, paper, gummed (sealing and securing) (3-inch) __________

Strapping, flat, steel

(

x 0.02-inch) _ __ __ ____________

Strapping seals -------------------------------------------------------

Wooden shipping box (19¼ x 18¼ x 10 inches inside dimen-

sions).

18 sq ft

35 sq ft

12 ft

10 ft

13 ft

2 each

1 ea