User Manual

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one of the

following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate this equipment.

For operation within 5.15 ~ 5.25GHz frequency range, it is restricted to indoor environment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. End users must follow the specific operating instructions for satisfying RF

exposure compliance. To maintain compliance with FCC RF exposure compliance requirements,

please follow operation instruction as documented in this manual.

This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

SAR compliance has been established in typical laptop computer(s) with USB slot, and product

could be used in typical laptop computer with USB slot. Other application like handheld PC or

similar device has not been verified and may not compliance with related RF exposure rule and

such use shall be prohibited.

The availability of some specific channels and/or operational frequency bands are country

dependent and are firmware programmed at the factory to match the intended destination. The

firmware setting is not accessible by the end user.

WUB-710A with Printed antenna and max. antenna gain is 1dBi in 2.4G and 2dBi in 5G.

CE Mark Warning

This is a Class B product. In a domestic environment, this product may cause radio interference,

in which case the user may be required to take adequate measures.

This transmitter must not be co-located or operation in conjunction with any other antenna or

transmitter.