User Manual

52
supports Wi-Fi Protected Setup and has a configuration button, you can add it to the network by pressing the
configuration button on the device and then the on the router within 60 seconds. The status LED on the router
will flash three times if the device has been successfully added to the network.
There are several ways to add a wireless device to your network. Access to the wireless network is controlled
by a “registrar”. A registrar only allows devices onto the wireless network if you have entered the PIN, or
pressed a special Wi-Fi Protected Setup button on the device. The router acts as a registrar for the network,
although other devices may act as a registrar as well.
Add Wireless Device Wizard
Start the wizard.
Advanced_ Advanced Network