User Manual

14
Hardware and Wireless Utility Installation
Follow the instructions below to install the PCI Card and Wireless Utility.
1. Turn off your computer‚ unplug the power cord and remove the computer's cover.
2. Pick a free PCI expansion slot and remover the protective bracket. Insert the Card into the slot until
it is fully seated.
3. Secure the Card bracket with the screw from step 2. Replace the computer’s cover.
4. Connect the external antenna to the Card from the SMA connector. And then, reconnect the power
cord and power on the computer.
5. After power on, you will get the “Found News Hardware Wizard” menu; click on Cancel.
6. Insert the Driver and Utility CD into CD drive.
7. If your CD Autorun is enabled, the Main Installation Menu will show. (Otherwise open your CD folder
and double-click on the “setup.exe” file)
8. The InstallShield Wizard prepares for installation.
9. The InstallShield Wizard prompts you for confirmation. Click Next on the following menu.