Quick Start Guide
QUICK START GUIDE
u-line.com
27
First Use
CRESCENT ICE MAKERS
Initial startup requires no adjustments.
U-Line recommends discarding the ice produced during the
or scale that may dislodge from the water line.
To turn the unit on or o:
Press the rocker switch located inside the door on the front
panel, or behind the grille.
REFRIGERATORS
Initial startup requires no adjustments. If the unit was
See “Control Operation” section for more details.
Temperature displayed reects actual
temperature inside unit.
unit is progressing towards the selected temperature. Time
to reach set point varies based upon ambient temperature,
temperature of product loaded, door openings, etc. U-Line
recommends allowing the unit to reach set point before
loading.
CONVERTIBLE FREEEZER
Initial startup requires no adjustments. If the unit was
OPERATION section for more details.
Temperature displayed reects actual
temperature inside unit.
unit is progressing towards the selected temperature. Time
to reach set point varies based upon ambient temperature,
temperature of product loaded, door openings, etc. U-Line
recommends allowing the unit to reach set point before
loading.
Approximate time required (empty unit) when converting
between refrigerator and freezer:
• 30ºF to 0ºF - 1 hour
• 0ºF to 38ºF - 4 hours
CLEAR ICE AND NUGGET ICE MACHINES
Initial startup requires no adjustments. See CONTROL
OPERATION section for more details.
U-Line recommends discarding the ice produced
during the rst two to three hours of operation
to avoid possible dirt or scale that may dislodge
from the water line.
When plugged in, the unit will begin operating under the
installation, simply press and the unit will immediately
Defrost
This unit requires manual defrost, periodically.
Inspect the interior walls for frost build up every 3 - 4
on the interior walls. Frost will build up faster in humid
environments and when the door is opened frequently.
open, and allow frost/ice to melt naturally. Do not use
tools to chip or scrape the frost as it may damage your
unit. Use a towel to absorb melting frost/ice. Before
turning the unit back on, make sure all the frost is gone
and the unit is dry.