Quick Start Guide

QUICK START GUIDE
u-line.com
21
1. 
bottom hinge. Retain shoulder washers; they will be
reused.
2. Insert arrow clips into holes
Remove bottom hinge:
1. Remove bottom hinge from cabinet using a 1/4”
socket.
2. Remove corresponding screws on opposite side of
cabinet. On some models there may be a nut behind
one or both screws on either side.
Install bottom hinge:
Install two or three screws, depending on model. Replace
nuts if used.
PREPARE DOOR FOR REINSTALLATION
Rotate gasket
1. 
putty knife, gently pry up
beneath the gasket and
spacer until completely free
from the door surface.
2. Continue removing the
gasket by grabbing hold
and gently pulling outward,
exposing the gasket
channel.
3. Remove the 3 pieces of
gasket channel filler.
4. Take out 2 screws and
remove plunger bracket
from gasket channel.
5. Install plunger bracket at the opposite corner, utilizing
the 2 pre-drilled holes.
6. Install 3 gasket channel filler pieces into the channel.
7. Install gasket, beginning at the corners and then
pressing gasket firmly into the channel on all three
sides.
8. Press down on middle
horizontal portion of
gasket until it adheres to
the door surface.
Gasket Channel
Filler
Gasket With Spacer
Beneath
Plunger
Bracket
Press down firmly
Note: It may be
necessary to apply
a strip of two-sided
tape for a firm
adhesion.
Gasket Channel
Plunger Bracket
Plunger
Bracket