User Guide & Service Manual

USER GUIDE

u-line.com

Door Adjustments

DOOR ALIGNMENT AND ADJUSTMENT

Align and adjust the door if it is not level or not sealing

properly. If the door is not sealed, the unit may not cool

properly, or excessive frost or condensation may form in

the interior.

NOTICE

Properly aligned, the door’s gasket should be

rmly in contact with the cabinet all the way

around the door (no gaps). Carefully examine the

door’s gasket to ensure that it is rmly in contact

with the cabinet. Also make sure the door gasket

is not pinched on the hinge side of the door.

Do not attempt to use the door to raise or pivot

your unit. This would put excessive stress on the

hinge system.

Alignment and Adjustment Procedure

1. Open door and remove gasket near the hinges.

2. Using a T-25 Torx bit, loosen each pair of Torx head

screws both the upper and lower hinge plates.

3. Square and align door as necessary.

4. Tighten Torx head screws on hinge.

5. Reinstall gasket into the channel starting at the corner.

REVERSING THE DOOR

1. Open door.

2. Using T-25 Torx bit loosen screw #1 and remove screw

#2 on top and bottom hinge. Slide and remove the

door from the unit.

Note: One hinge includes a metal spacer. Spacer

must be used with that hinge when reversing the

door.

3. Remove caps from screw heads on opposite side (2 on

top and 2 on bottom). Using #2 Phillips bit, remove

the 4 underlying screws. Reinstall the screws and caps

on the opposite side.

4. Partially install screw #1 in the outer most holes on

top and bottom. Rotate door 180o, align hinge over

screw #1 and slide/seat into position. Reinstall screw

#2 on top and bottom. Tighten both screws and install

hinge cover.

Align and adjust the door:

Align and adjust the door (see DOOR ALIGNMENT AND

ADJUSTMENT).

T-25 Torx Screw

CAUTION