Use and Care Manual

USER GUIDE

u-line.com

Door Adjustments

3. Remove door by tilting forward and lifting door o

bottom hinge. Retain shoulder washers; they will be

reused.

4. Remove three screws from hinge holes on the

opposite side. Reinstall into holes where the hinge was

removed. (If utilizing supplied screw cover, install just

one screw.)

Remove bottom hinge:

1. Remove bottom hinge from cabinet using a T-25 TORX

screw driver to remove three screws.

2. Remove corresponding screws on opposite side of

cabinet. On some models there may be a nut behind

one or both screws on either side.

Install bottom hinge:

Install two or three screws, depending on model. Replace

nuts if used.

Install top hinge and door:

1. Install hinge with longer straight edge aligned to

outside edge of cabinet. Do not tighten.

2. Rotate door 180

and set on bottom hinge.

3. Align edge of the hinge with the outer edge of the unit.

4. Tighten three hinge screws.

Align and adjust the door:

Align and adjust the door (see DOOR ALIGNMENT AND

ADJUSTMENT)

Install grille and hinge cover