Quick Start Guide

QUICK START GUIDE

u-line.com

4. Remove three screws from hinge holes on the opposite

side. Reinstall into holes where the hinge was

removed.

Remove bottom hinge:

1. Remove bottom hinge from cabinet using a T-10 TORX

screw driver to remove three screws.

2. Remove corresponding screws on opposite side of

cabinet. On some models there may be a nut behind

one or both screws on either side.

Install bottom hinge:

Install two or three screws, depending on model. Replace

nuts if used.

Prepare door for reinstallation:

1. Remove gasket. This will reveal mounting holes for the

magnet assembly.

2. Remove magnet assembly from door with T-10 TORX

driver. Be sure to only remove the two screws holding

the assembly to the door. Reinstall on the opposite end

of the door.

3. Rotate gasket 180°, aligning notch with magnet

assembly and pressing firmly into the gasket channel

starting at the corners.

4. Rotate door 180° to reverse.

Install top hinge and door:

1. Install hinge with longer straight edge aligned to

outside edge of cabinet. Do not tighten.

2. Lift the door on to the bottom hinge.

3. Align edge of the hinge with the outer edge of the unit.

4. Tighten three hinge screws.

Align and adjust the door:

Align and adjust the door (see DOOR ALIGNMENT AND

ADJUSTMENT).