quick start_guide

ManualsBrandsU-Line ManualsSingle Zone Wine CoolersU-Line 24 Inch Wide 14 Wine Bottle and 111 Can Capacity Built-In or Free Standing Wine and Beverage Cooler with LED Lighting

QUICK START GUIDE

u-line.com

Door Swing

For Integrated models that are installed adjacent to a wall,

1/2” (13 mm) clearance is recommended from wall on

hinge side to allow the door to open 90°. Allow for

additional space for any knobs or pulls installed on the

integrated panel/frame.

Stainless Steel models that are installed adjacent to a wall

require 2-1/4” (57 mm) door clearance on hinge side to

allow for door handle.

Units have a zero clearance when installed adjacent to

cabinets.

Door Adjustments

DOOR ALIGNMENT AND ADJUSTMENT

Align and adjust the door if it is not level or not sealing

properly. If the door is not sealed, the unit may not cool

properly, or excessive frost or condensation may form in

the interior.

NOTICE

Properly aligned, the door’s gasket should be

rmly in contact with the cabinet all the way

around the door (no gaps). Carefully examine the

door’s gasket to ensure that it is rmly in contact

with the cabinet. Also make sure the door gasket

is not pinched on the hinge side of the door.

Do not attempt to use the door to raise or pivot

your unit. This would put excessive stress on the

hinge system.

Alignment and Adjustment Procedure

1. Open door and remove gasket near the hinges.

2. Using a T-25 Torx bit, loosen each pair of Torx head

screws both the upper and lower hinge plates.

3. Square and align door as necessary.

4. Tighten Torx head screws on hinge.

5. Reinstall gasket into the channel starting at the corner.

T-25 Torx Screw

Wall

90°

Door Swing

90°

Door Swing

Space Required

For any Knobs or Pulls

2-1/4" MIN

(57 mm MIN)

3000 Series

Integrated

Stainless

1/2" (13 mm)