Quick Start Guide

QUICK START GUIDE
u-line.com
General Installation
LEVELING INFORMATION
To comply with applicable federal, state, and local
codes, this equipment may need to be caulked to the
oor.
1. 

placed along top edge and
side edge as shown.
2. If the unit is not level, adjust
the legs on the corners of the
unit as necessary.
3. 
repeat the previous steps as needed.
INSTALLATION TIP

opening, adjust the rear legs to achieve a total unit rear
height of ” (3 mm) less than opening’s rear height.
Shorten the unit height in the front by adjusting the front
legs. This allows the unit to be gently tipped into the
opening. Readjust the front legs to level the unit after it is
correctly positioned in the opening.
INSTALLATION
1. 
2. Gently push the unit into position. Be careful not
to entangle the cord or water and drain lines, if
applicable.
3. Re-check the leveling, from front to back and side to
side. Make any necessary adjustments. The unit’s top
surface should be approximately ” (3 mm) below
the countertop.
4. Install the anti-tip bracket.
5. Remove interior packing material and wipe out the
inside of the unit with a clean, water-dampened cloth.
1
Turn to Adjust
7
Anti-Tip Bracket
FLOOR MOUNTED ANTI-TIP INSTALLATION
1. 
2. 

to make sure the door opens and closes freely.
3. 

of the unit.
4. Remove the unit. Using a square, extend center line
“B” (see chart
below). This
line serves as
the back edge
for the anti-tip
brackets. From
the center line,
measure “A”
to the left and
right. This line is
the outer edge of
each bracket.
515 518 524
A 7   11 ”
B 22” 22” 22”
5. 
drawn for the outer edge. Mark spots for the screw
holes.
6. Use a 1/8” drill to
make two starter
holes and fasten
the anti-tip
brackets to the

screws provided.
7. 
unit back
into position,
making sure
the feet engage the anti-tip brackets properly. Check

3 with the position of the front feet to ensure proper
positioning.
C
L
Surrounding
area (Top view)
Drill holes and
mount anti-tip
brackets to floor
Back wall
Front
of
unit
Back
of
unit
A
A
B
C
L
Back wall
Back of unit
Front of unit
Surrounding
area (Top view)
A
A
B
CAUTION
!