Quick Start Guide

QUICK START GUIDE

u-line.com

USER GUIDE

u-line.com

General Installation

2. Install adapter plate to unit with 4 long screws and nuts

(a) then place foam rubber gasket on top - open holes

aligned (b).

3. Insert all 4 hoses into the opening.

4. Install tower to unit with 4 short Philips screws.

NOTE: It will be necessary to press down rmly while

tightening the screws. Compressing the foam rubber gasket

ensures an airtight seal between the unit and the tower.

Connect Hoses to Tower

Your tower comes with two hoses already attached.

1. Attach gas jumper hose - line up and press in rmly.

Note: The connector at the end of the gas jumper line is

narrower to correspond with the connection in the tower.

2. Attach liquid jumper hose - line up and press in rmly.

Note: The connector at the end of the liquid jumper line is

wider to correspond with the connection in the tower.

Install Tower on Refrigerator

Do not remove all the protective lm on the stainless

exterior until the tower is installed.

1. Remove four Phillips screws (secured with nuts on

the inside of the refrigerator) and lift o cap to reveal

tower mounting hole. Peel back enough lm for tower

to clear.

Rubber Gasket

Adapter Plate

4 Long Screws

Foam Rubber Gasket

4 Short Screws

Metal Ring

4 Nuts

4 Acorn Nuts