Quick Start Guide

QUICK START GUIDE
u-line.com
18
Temperature displayed reects actual
temperature inside unit.
Initial startup requires no adjustments. If the unit was
turned o, press and hold for 5 seconds to turn unit on.
See “Control Operation” section for more details.
If the temperature displayed is dierent than selected, the
unit is progressing towards the selected temperature. Time
to reach set point varies based upon ambient temperature,
temperature of product loaded, door openings, etc. U-Line
recommends allowing the unit to reach set points before
loading.
To dispense cold coee, make sure the components are
assembled according to the instructions in GENERAL
INSTALLATION.
NOTICE
First Use
Control Operation
CONTROL FUNCTION GUIDE
FUNCTION COMMAND NOTES
ON/OFF Press and hold for 5 seconds Unit will turn On or OFF
Adjust Temperature Press or and release
When the display is ashing, press or to
adjust the set point temperature.
Toggle between
º
F /
º
C Hold and for 5 seconds The display will change units
Restricting airow may result in poor product
performance, product failure, and uneven internal
temperatures and may freeze contents.
Do not block the front grille - no additional clearance
around sides, top or rear of unit is needed for ventilation
Do not install behind a closed door
When loading, leave space between internal fans, vents,
and side walls to allow air to circulate freely
NOTICE
AIRFLOW
External
Internal
Airow and Product Loading