Quick Start Guide
QUICK START GUIDE
u-line.com
USER GUIDE
u-line.com
General Installation
In Valve
Connect Nitrogen to Kegs
1.
2. Insert one end of hose into elbow on infuser regulator.
3. Attach T-connector to other end of hose.
4. Connect gas line from the tower to end of T-connector.
5. Connect blue gas line to center of T-connector.
6. Attach gray coupler of the gas jumper line to keg. With
your thumb press down on the top of the coupler while
valve. Release collar - listen for a click. Pull up on the
coupler to ensure it is locked down.
Other end is connected to
T- connector on Infuser
Regulator
1
2
7. Attach and clamp blue hose to lo-boy coupling.
Connecting Internal CO
2
Source
Install Regulator
NOTE: Make sure gas valve on tank and two
gas valves on regulator are turned all the way
clockwise to the o position.
1. Attach regulator to CO
2
tank. Hand tighten the
coupling nut and then use an adjustable wrench for an
additional quarter turn. DO NOT OVER TIGHTEN
2. Attach” CO
2
hose (blue) to each regulator nipple
and clamp into place. If necessary, make the hose
more pliable by heating the end in boiling water.
3. Attach and clamp CO
2
hose to lo-boy coupling.
2
3
4
5
From
Tower
To Slim Keg
14