Quick Start Guide

QUICK START GUIDE
u-line.com
USER GUIDE
u-line.com
General Installation
Connecting Internal Nitrogen
Source
Install Infuser Regulator
1. Align infuser regulator with pre-drilled holes in upper
left/right of interior side wall. Use 2 screws to secure.
Nitrogen Connections
1. Attach ball valve
(not included) to
tank regulator (not
included).Tighten
with an adjustable
wrench. Make sure
valve is in the o
position - turned
clockwise as far as it
can go.
2. Attach regulator
to nitrogen
tank. Hand
tighten the
coupling nut
and then use
an adjustable
wrench for
an additional
quarter turn.
DO NOT OVER
TIGHTEN.
NOTE: Make sure valve is in the o position - turned
clockwise as far as it can go.
3. With a knife, cut o one end of the
nitrogen braided line.
4. Attach braided line to ball valve on tank regulator
using white snap ring.
5. Attach other end of braided line to T- connector on
infuser regulator.
6. Attach gas jumper line to T-connector on infuser
regulator - line up and press in rmly.
Interior Left
Side Wall
To Tap Tower
Ba
c
k
W
a
ll
B
u
lkhe
ad
psi
0
2
4
6
8
1
0
1
2
1
4
Nitrogen IN
From Source
Nitrogen OUT
To Ball-tap Keg
Nitrogen OUT
To Slim Keg and Tower
T-Connector
T-Connector
To Ball-tap
Keg
12