User Guide & Service Manual

USER GUIDE

u-line.com

General Installation

2. Install adapter plate to unit with 4 long screws and nuts

(a) then place foam rubber gasket on top - align holes (b).

3. Insert all 4 hoses into the opening.

Note: 2 of the connections inside tower have color banding to





refrigerator.

4. Install tower to unit with 4

short Philips screws.

NOTE: It will be necessary



tightening the screws.

Compressing the foam rubber

gasket ensures an airtight seal

between the unit and the tower.

Connect Hoses to Tower



installing tower onto refrigerator.

1. 

Note: The connectors at the ends of the gas jumper hoses

are narrower to correspond with the connections in the

tower.

2. Attach liquid jumper hoses - line up and press in



Note: The connectors at the end of the liquid jumper hoses

are wider to correspond with the connections in the tower.

Install Tower on Refrigerator



exterior until the tower is installed.

1. Remove four Phillips screws (secured with nuts on



tower mounting

hole. Peel back



tower to clear.

Rubber Gasket

Adapter Plate

4 Long Screws

Rubber Gasket

4 Short Screws



4 Nuts

4 Acorn Nuts