Quick Start Guide

QUICK START GUIDE
u-line.com
12
USER GUIDE
u-line.com
General Installation
Connecting Internal Nitrogen
Source
Install Infuser Regulators
1. Align each infuser regulator with pre-drilled holes in
upper left/right of each side wall. Use 2 screws to
attach each regulator.
Assemble and connect tank regulator to tank
1. Attach ball valve to tank regulator (not included).
Tighten with an adjustable wrench. Make sure valve is
in the o position - turned clockwise as far as it can
go.
2. Attach regulators to nitrogen tank. Hand tighten the
coupling nut and then use an adjustable wrench for an
additional quarter turn. DO NOT OVER TIGHTEN.
3. Attach nitrogen
hose to ball valve on tank regulator.
Make sure valve is in the o position - turned
clockwise as far as it can go.
4. Attach other end of nitrogen
hose to T- connector on
gas line that goes to each infuser regulator.
Interior Left
Side Wall
To Tap Tower
Ba
c
k
W
a
ll
B
u
lkhe
ad
psi
0
2
4
6
8
1
0
1
2
1
4
Nitrogen IN
From Source
Nitrogen OUT
To Ball-tap Keg
Nitrogen OUT
To Slim Keg and Tower
T-Connector