User Guide & Service Manual

USER GUIDE
u-line.com
General Installation
Connecting Internal Nitrogen
Source
Install Infuser Regulator
1. Align infuser regulator with pre-drilled holes in upper
left corner of side wall. Use 2 screws to attach.
Assemble and connect tank regulator to tank
1. Attach ball valve to tank regulator (not included).
Tighten with an adjustable wrench. Make sure valve is

go.
2. Attach regulator to nitrogen tank. Hand tighten the
coupling nut and then use an adjustable wrench for an
additional quarter turn. DO NOT OVER TIGHTEN.
3. Attach nitrogen
hose to ball valve on tank regulator.

clockwise as far as it can go. Tighten hose clamp.
4. Attach other end of nitrogen
hose to T connector on

Connect nitrogen to keg
1. Attach gas jumper line to T connector on infuser

T-Connector
T-Connector
10
1
2
3
4
5
6
7
8
9
13
14
15
12
11
Interior
Side Wall
To Tap Tower
14