User Guide & Service Manual
USER GUIDE
u-line.com
General Installation
1. Use template to drill four mounting holes.
2.
3.
hole.
4. Slide keg refrigerator into place.
5. Position gasket over mounting hole.
6.
7. Secure tower to countertop using four Phillips screws and nuts.
8. Continue with CO
to install air-tight insulation between the refrigerator and
the tower. The insulation will need to run from the interior of the refrigerator up into the interior of the tower.
Front Face
of Unit
2 ¾”
(70 mm)
Hole Diameter
Power Cord
2”
(51 mm)
15”
(381 mm)
Rear Wall
24 ¼”
(616 mm)
12 ½”
(318 mm)
11 ⁄”
(283 mm)
1 ⁄”
(43 mm)
7 ½”
(19 1 mm)
Rear Wall
Countertop
11-1/8”
(283 mm)
Front edge of drilled hole
to front face of unit
Beverage
Tube
Insulation
Diagram A
Diagram B
Insulation
12