User Guide
USER GUIDE
General Installation 1
u-line.com
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
General Installation
LEVELING INFORMATION
1. Use a level to 
confirm the unit is 
level. Level should 
be placed along top 
edge and side edge 
as shown.
2. If the unit is not level, adjust the feet on the corners of 
the unit as necessary.
3. Confirm the unit is level after each adjustment and 
repeat the previous steps until the unit is level.
INSTALLATION TIP
If the room floor is higher than the floor in the cutout 
opening, adjust the rear feet to achieve a total unit rear 
height of 1/8" (3 mm) less than the opening’s rear height. 
Shorten the unit height in the front by adjusting the front 
feet. This allows the unit to be gently tipped into the 
opening. Readjust the front feet to level the unit after it is 
correctly positioned in the opening.
INSTALLATION
This model is intended for indoor/interior applications only 
and is not to be used in installations that are open/
exposed to natural elements.
1. Plug in the power cord.
2. Gently push the unit into position. Be careful not to 
kink the water supply line or entangle the power cord.
3. Re-check the leveling, from front to back and side to 
side. Make any necessary adjustments. The unit’s top 
surface should be approximately 1/8" (3 mm) below 
the countertop.
4. Remove the tape from the glass shelves and wipe out 
the inside of the unit with a clean, water-dampened 
cloth.
1
Turn Foot to Adjust










