User Guide
USER GUIDE
First Use 1
u-line.com
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
First Use
All U-Line controls are preset at the factory. Initial startup 
requires no adjustments. 
NOTICE
U-Line recommends allowing the unit to run 
overnight before loading with product.
To turn the unit on or off: 
Press the rocker switch located below the temperature 
control dial in the center of the grille. 
CONTROL DIAL
The control dial sets a single continuous temperature. 
This set point temperature is a base setting used by the 
controller to maintain the temperature zone in the unit. 
The factory default MID setting, number 3 or 4 set point, 
is approximately 38°F (3°C). The set point temperature is 
a gauge for further temperature adjustments.
OFF
ON










