User Guide & Service Manual
USER GUIDE
Remove Fan and Cover 2
u-line.com
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
11.Grasp evaporator cover, pull the top forward and up as 
bottom of cover is installed behind the front edge of 
the drain trough.
12.While pulling the evaporator cover clear of the unit, it 
may be necessary to use your free hand to manipulate 
the fan plug end through the pass-through hole. 
13.Remove the 4 screws mounting the fan shroud to the 
evaporator plate. 
14.Remove and replace fan. Take special care to properly 
route fan wire. 
NOTICE
Fan must be oriented to pull air in through lower 
evaporator cover vents and push air out at fan 
mounting location.
15.Installation is the reverse of removal.
16.Care must be taken to assure the bottom of the 
evaporator cover is reinstalled behind the front edge of 
the drain trough.
17.Use sealant gum to seal any openings at the rear of 
the unit before replacing rear cover.
18.Reinstall unit taking care to level, space and secure as 
found.
Air Flow
55










