Use and Care Guide Wine Captain® Model: 1075WC 1075WC
1 Introduction Congratulations on your purchase of a U-Line refrigeration product. A pioneer in the field for more than 40 years, U-Line Corporation is the world’s number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-Line dedicates 100% of its research and development to these products. The result: U-Line technology consistently leads the market with innovation, design, depth of product line and performance.
2 Table of Contents Introduction ...............................................................................................................................2 Warranty Registration .......................................................................................................2 Please Record Your Model Information ...........................................................................2 Table of Contents ...........................................................................................
WARNING 3 Safety Precautions IMPORTANT PLEASE READ all instructions completely before attempting to install, operate, or service your unit. • Proper installation procedures must be followed if this unit is being initially installed, or is moved to a new location after being in service. An INSTALLATION GUIDE for your unit, providing complete installation information is available from U-Line Corporation directly, and must be consulted before any installation is begun.
4 Product Features 5 Operation Origins Wine Captain® Model1075WC Air Flow The Origins Wine Captain Models feature specially designed canted wine racks that allow for the proper horizontal storage of wine. The corks remain moist, which keeps air from entering the bottles. Model 1075WC will accommodate up to 48 bottles (750 mL size).
• Temperature setting. WARNING • Ambient temperature where installed. Electrical Shock Hazard. Disconnect power before servicing. Before operating, replace all panels. Failure to do so may result in death or electrical shock. • The number of times and length of time the door is opened and closed. • Installation in direct sunlight or near a heat source. Normal Operating Sounds 1. Remove all consumable contents from the unit.
bottle that is partially filled with water. Tighten the bottle cap securely (Figure 4). Suggestions for Matching Food and Wine Place the bottle in the desired area for 24 hours. Refrain from opening the unit during the testing period. After 24 hours, check the temperature control in a small increment (See ADJUSTING TEMPERATURE). As a general rule, one should aim to ascend in flavor and quality of wines served. Factors which affect the internal temperatures of the cabinet include: • Temperature setting.
Guide to Common Styles of Wine Red Wines Full-Bodied Dry California French Italian Zinfandel, Cabernet Rhone, Chateauneuf-du-Pape Barbaresco, Barolo Medium-Bodied Dry California French Pinot Noir Bordeaux, Burgundy Light-Bodied Dry French Italian Beaujolais Chianti, Bardolino Full-Bodied Dry California French Chardonnay Montrachet, Meursault Puligny-Montrachet Medium-Bodied Dry California French Sauvignon-Blanc Pouilly-Fuisse, Sancerre, Vouvray, Graves Light-Bodied Dry French Chablis, Musca
Maintenance 6 Cleaning and Maintenance Proper maintenance of your U-Line product will ensure efficiency, top performance and long life. The maintenance intervals listed are based on normal conditions. You may want to shorten the intervals if you have pets or other special considerations. Cleaning Exterior Cleaning (As Required) Vinyl Clad • Surfaces may be cleaned with a mild detergent and warm water solution. Do not use solvent-based or abrasive cleaners. Use a soft sponge and rinse with clean water.
To defrost: 4. Clean the condenser coil (Figure 7, ) using a soft brush with a “combing” action or vacuum cleaner. Do not touch condenser coil. 1. Turn unit off. 2. Remove all products from the interior and prop the door in an open position (2 in. (5 cm) minimum). Condenser coil 3. Allow the frost to completely melt naturally. Clean the interior and all removed components using a mild nonabrasive detergent and warm water solution applied with a soft sponge or non-abrasive cloth.
1. Use a level to check the levelness of the unit from front to back and from side to side. Level should be placed along top edge and side edge as shown (Figure 9). 1. Loosen (do not remove) top (Figure 11) and bottom hinge screws. 2. Align door squarely with cabinet. 3. Make sure gasket is firmly in contact with cabinet all the way around the door (no gaps). 4. Tighten bottom hinge screws. 5. Tighten top hinge screws. Grille Installation Adjustable foot Grille Screw ULIN_0042_A Figure 10 2.
Light Bulb Replacement IMPORTANT To replace the light bulb in your U-Line unit: Do not remove the track side rails from the cabinet. To insert a rack in the cabinet: 1 1. Align the left and right rack channels with the tracks in the cabinet, and ensuring an even track engagement on both sides, gently push the rack into the cabinet until it stops. 2 2.
stain to penetrate approximately three minutes. Before the stain is dry, take a stain dampened rag and remove any excess stain remaining. Wipe in the direction of the grain with medium pressure to achieve the desired stain color. 3. After two hours, repeat step 2. This will even out the color of the wood. 4. Allow stain to dry for a minimum of three hours before applying the final finish. 5. If desired, sand the wood with very fine sandpaper to smooth the surface after the staining process. 6.
TROUBLESHOOTING GUIDE DANGER ELECTROCUTION HAZARD Never attempt to repair or perform maintenance on the unit until the main electrical power has been disconnected. PROBLEM POSSIBLE CAUSE REMEDY Unit does not operate. No electrical supply. Plug unit in or check circuit breaker. No interior light Loose or burned out bulb Tighten or replace bulb (See MAINTENANCE; LIGHT BULB REPLACEMENT). Light won’t go out when door is closed. Light on/off switch is turned to ON. Turn switch to OFF (see OPERATION).
U-Line Corporation Limited Warranty U-Line Corporation warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, the evaporator, the hot gas bypass valve, the dryer and the connecting tubing) in each U-Line product to be free from defects in materials and workmanship for a period of five years from the date of purchase.
For General Inquiries: P.O. Box 245040 Milwaukee, Wisconsin 53224-9540 U.S.A. Phone (800) 779-2547 FAX (414) 354-5696 www.U-Line.com For Service and Parts Assistance: Phone (800) 779-2547 (414) 354-0300 FAX (414) 354-5696 Email: OnLineService@U-Line.com www.U-LineService.com E-mail: OnlineParts@u-line.com For more than four decades, U-Line has distinguished itself as the leader in built-in under-counter ice making, refrigeration and wine storage appliances.
