User guide

USER GUIDE

Light Replacement 1

u-line.com

SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE

Light Replacement

To replace the light bulb in your U-Line unit:

NOTICE

ALWAYS use a genuine U-Line replacement 120V

10 watt bulb (Part Number 31317) in the light

housing. Use of any other bulb within the

housing will produce excessive heat, causing

damage to the light housing and cabinet interior,

and will compromise the precise temperature

control of the unit.

1. Find the light located at the top of the unit. Grasp the

edges of the light housing lens (1) opposite the

exposed tab and gently push the lens toward the tab

(2).

2. Pull the edge of the lens down (1) and swing it out of

the light housing.

3. Remove old light bulb and install new light bulb into

receptacle.

4. Replace the lens by first inserting the tab side back into

the housing at a slight angle.

5. While gently pushing the lens towards the tab end,

push the free end into the housing, and release when

you hear a snap.