User Guide & Service Manual
USER GUIDE
Integrated Panel Installation 2
u-line.com
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
12.Using a Phillips screwdriver, place one screw into each 
of the 6 pilot holes and screw down. Do not overtighten 
screws.
13.Be sure the screws force their way past the opening on 
the gasket channel and sit flush against the bottom of 
the channel.
14.Remove clamps from door/drawer.
NOTICE
If panel requires additional adjustment after 
removing clamps, slightly loosen each screw and 
adjust panel as necessary. Tighten screws upon 
completion.
15.Starting at the corners, re-install the gasket into the 
gasket channel in the frame. Make sure the gasket is 
fully seated. This may take some force.
Integrated Panel
Integrated Panel
17










