Troubleshooting guide

18 CLR2160, CLRCO2175

Insert the shelves as follows:

1. To move to a different position in the unit, insert shelf

at an angle, approximately 15-20°, over the rib in the

side of the unit where you want to place the shelf. The

shelf must be started into the unit at an angle to clear

the door.

2. Continue to slide the shelf into the unit at an angle

until it clears the door.

3. Lower the shelf and push it in completely.

Light Bulb Replacement

CLRCO2175

To replace the light bulb in your U-Line unit:

Figure 30

1. Grasp the edges of the light housing lens

(Figure 30, 1) opposite the exposed tab, and gently

push the lens towards the tab (Figure 30, 2).

2. Pull the edge of the lens down

(Figure 30, 1)

, and

swing it out of the light housing.

IMPORTANTIMPORTANT

ALWAYS use a genuine U-Line replacement bulb (P/N

31317) in the light housing. Use of any other bulb

within the housing will generate excessive heat,

causing damage to the light housing and cabinet

interior, and compromising the precise temperature

control of your unit.

3. Replace the bulb only with a genuine U-Line P/N 31317

replacement.

4. Replace the lens by first inserting the tab side back into

the housing at a slight angle. While gently pushing the

lens towards the tab end, push the free end up into the

housing, and release when you will hear a snap/click.

ULIN_0001_A