Troubleshooting guide

CLR2160, CLRCO2175 17
5. Remove the two door closer inserts (Figure 26, 1) from
the existing bottom hinge and install as shown on the
new bottom hinge (Figure 25, 1) .
6. Remove existing bottom hinge (three screws) and
remount on opposite side TOP. Remove hinge screw pin.
7. Remove the plastic hole plug from the top of the door
to allow the pivot pin to be inserted in the new
location. Install the plug into the vacated hole on the
opposite side.
Figure 27
8. With bottom of door facing up, remove pivot plate
(two screws), flip over, and remount on opposite side of
door (Figure 27) . Be sure notch in plate faces
center.
9. Holding door upright with top of door tilted forward,
place hole of door pivot plate on bottom hinge screw
pin/closer inserts
(Figure 25, 1) .
10. Tilt top of door into position in top hinge and install top
hinge screw pin.
11. Install plastic screw plugs removed in Step 2 in old hinge
holes (three each, top and bottom).
Door Shelf Removal/Insertion
Figure 28
To remove the door shelf:
1. Grasp shelf in center, lift slightly, and tilt 15°-20°.
2. Carefully pull shelf off bosses (Figure 28, 2) .
To install the door shelf:
1. Holding shelf in center, align notches (Figure 28, 1) in
shelf with bosses (Figure 28, 2) in door.
2. Tilt shelf at a 15°-20° angle and slide onto bosses at the
desired location.
Glass Shelf Removal/Installation
Figure 29
1. Pull shelf out about 6" (Figure 29, 1) until back of
shelf clears the "hump" on the right-hand side.
2. Tilt right-hand edge of shelf up.
3. Remove shelf from unit by pulling out
(Figure 29, 2) .
ULIN_0006_A
1
2
ULIN_0039_A
ULIN_0276_A
1
2