Installation guide

05/2007 9 www.U-LineService.com
CLR2160/CLRCO2175 Ice Makers
Side-By-Side Installation
Instructions CLRCO2175
For a complete refreshment center, install your
CLRCO2175 Clear Ice Maker/Refrigerator beside a U-Line
Drawer or Wine Captain Model (see Figure 15 for typical
cut-out). Note that each Side-By-Side Installation will be
different.
• Cut-out width for a side-by-side installation is the total
of the widths listed under Cut-Out Dimensions in each
unit’s Installation Guide.
For example:
Placing a CLRCO2175 Clear Ice Maker/Refrigerator next
to a 2115 series unit would require a cut-out width of:
24-3/16" + 15-3/16" = 39-3/8".
Placing a CLRCO2175 Clear Ice Maker/Refrigerator next
to a 2175 series unit would require a cut-out width of:
24-3/16" + 24-3/16" = 48-3/8".
•
No trim kit is required. However, 1/4-inch space needs to
be maintained
between the units to ensure
unobstructed door swing.
• Units must operate from separate, properly grounded
electrical receptacles placed according to each unit’s
Electrical Specifications.
(Black and White Units Only)
Two types of custom door panels can be installed on your
Black or White unit to harmonize with or accent the
surrounding décor: a Custom 1/4" Insert or a Full Overlay.
If no custom door panel is used, go on to 5 Adjust Door.
Custom 1/4'' Door Panel Insert
Door Panel Preparation
A custom door panel can be inserted into the doorframe.
Custom door panels can be flat or raised, as long as the
maximum panel thickness where inserted into the door
reveal (channel) is 1/4"-thick. For raised panels, the depth
of the reveal is 1/4" on all four sides.
IMPORTANT
Raised panels will reduce the door’s 90° swing/zero
clearance if the unit is installed next to a wall or similar
type of structure.
For 2175 models cut the panel insert to the following
dimensions.
Custom 1/4" Dimensions:
Width: 23-1/32"
Height: 27-11/16"
For 2115 & CLR2160 models cut the panel insert to the
following dimensions.
Custom 1/4" Dimensions:
Width: 14-1/32"
Height: 27-11/16"
The door panel must not weigh more than 20 lbs.
Door Panel Installation
Install the insert as follows:
CAUTION
Use care when handling the insert. Insert edges may be
sharp.
1. Remove top hinge screw pin (using a Phillips
screwdriver, see Figure 16). Remove door by tilting
forward and lifting off bottom hinge pin.
Preferred
Location for
CLRCO2175
Receptacle
Acceptable
Location
1-1/2"
7"
24"
34-1/4"
to
35-1/8"
1/4" Space
Between
Appliances
Figure 15
Typical Side-By-Side Cut-Out
4 Prepare and Install Door Panel