Installation guide

www.U-LineService.com 10 05/2007
CLR2160/CLRCO2175 Ice Makers
2. Pull door gasket out of groove (top edge of door only).
Start in the middle and pull outward, moving toward
the edge (see Figure 17 ). This may take some force.
3. Remove two outside screws holding door handle.
Slightly separate door handle from door (see
Figure 18 ).
4. Pull handle up and off.
5. Remove and discard
existing panel and
cardboard spacer.
6. Slide custom door panel
insert into 1/4-inch
channel in door front.
7. Holding door gasket out
of the way, replace handle
on door, making sure it is
seated properly on insert
and that screw holes line up.
8. Install two small screws removed in Step 3.
9. Starting at the corners and working inward, push door
gasket into place on door.
10. Place door on bottom hinge pin and install upper hinge
screw.
Full Overlay Door Panel
Door Panel Preparation
A full overlay door panel completely covers the
doorframe and handle to give a built-in appearance. See
your U-Line dealer for the optional Full Overlay Door
Panel Kit.
2175 Models:
P/N U-OL2175B -- Black
P/N U-OL2175W -- White
2115 & CLR2160 Models:
P/N U-OL2115B -- Black
P/N U-OL2115W --White
Appropriate hardware, Modified Handle, Replacement
Hinges and a copy of these instructions will be included in
the kit.
1. Cut the overlay to the following dimensions (see
Figure 19).
Full Overlay Dimensions:
2175 Models: 2115 & CLR2160 Models:
Width: 23-3/4" Width: 14-3/4"
Height: 29-3/4" Height: 29-3/4"
The door panel must not weigh more than 20 lbs.
IMPORTANT
Rear View of wood panel for right-hand hinge shown. Use
mirror image for left-hand hinges.
ULIN_0133a_
A
Figure 16 Figure 17
Figure 18
Height
Width
31/32"
Relief Notch
for Pivot Plate
Rear View
of
Wood Panel
3/4"
1/8"
ULIN_0400_A
Figure 19