User`s manual

Install the insert as follows:
Insert edges may be
SHARP! Use care when
installing.
1. Remove top hinge screw pin
(7/64" Allen wrench, see Figure
20). Remove door by tilting
forward and lifting off bottom hinge pin.
2. Remove two outside screws hold-
ing door handle. Slightly
separate door handle from door
(see Figure 21).
3. Pull door gasket out of groove
(top edge of door only). Start in
the middle and pull outward,
moving toward the edge (see
Figure 22). This may take some
force. Do not remove the three
screws behind gasket.
4. Pull handle up and off.
5. Slide custom door panel insert into
1/4 inch channel in door front.
6. Holding door gasket out of the
way, replace handle on door
making sure it is seated properly
on insert and that screw holes line
up.
7. Install two small screws removed
in step 2.
8. Starting at the corners and
working inward, push door gasket
into place on door.
9. Place door on bottom hinge pin
and install upper hinge screw.
!
WARNING
User’s Manual
UL310
UL132
UL117
18