Quick Start Guide

QUICK START GUIDE
u-line.com
QUICK START GUIDE
13
u-line.com
First Use
All U-Line controls are preset at the factory. Initial startup
requires no adjustments.
NOTICE
U-Line recommends allowing the unit to run
overnight before loading with product.
1200 SERIES
When plugged in, the unit will begin operating under the
factory default settings. If the unit was turned off during
installation, press and hold for 5 seconds to turn unit
on.
1024BEV/1024R
MECHANICAL DIAL CONTROL
The control dial turns unit ON/OFF and sets temperature.
This set point temperature is a base setting used by the
controller to maintain the temperature zone in the unit.
The factory default MID setting, number 4 set point, is
approximately 38°F (3°C). The set point temperature is
a gauge for further temperature adjustments.
1024WC
MECHANICAL DIAL CONTROL
The control dial turns unit ON/OFF and sets temperature.
This set point temperature is a base setting used by the
controller to maintain the temperature zone in the unit.
The factory default MID setting, number 3 or 4 set point,
is approximately 50°F (10°C). The set point temperature
is a gauge for further temperature adjustments.
13
Copyright © 2021/2022 U-Line Corporation. All Rights
Reserved. Publication Number 30628 12/2021 Rev.B