ULIN_016357_30090.
1 Introduction Congratulations on your purchase of a U-Line refrigeration product. A pioneer in the field for more than 40 years, U-Line Corporation is the world’s number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-Line dedicates 100% of its research and development to these products. The result: U-Line technology consistently leads the market with innovation, design, depth of product line and performance.
2 Table of Contents Introduction ...............................................................................................................................2 Warranty Registration .......................................................................................................2 Please Record Your Model Information ...........................................................................2 Table of Contents ...........................................................................................
This page intentionally left blank 4 2115R, 2175R
WARNING 3 Safety Precautions IMPORTANT PLEASE READ all instructions completely before attempting to install, operate, or service your unit. • Proper installation procedures must be followed if this unit is being initially installed, or is moved to a new location after being in service. An INSTALLATION GUIDE for your unit, providing complete installation information is available from U-Line Corporation directly, and must be consulted before any installation is begun.
• Two contoured, self-contained, inner door “pick-off” shelves are adjustable for storage of a variety of different bottle, can, and container sizes and shapes. 4 Product Features Échelon Refrigerator Models 2115R, 2175R • The lower inner door shelf accommodates a two liter or 750 mL bottle. Exclusive Features of Échelon • Self-closing door hinges engage when the door is open approximately 8-10 in. (20-25 cm), ensuring a positive door seal and preventing door bounce back. • Model 2115R is a 3.
Temperature Control 5 Operation Checking Product Temperature ULIN_0080_A Figure 2 IMPORTANT Proper air flow (Figure 2) is required for your unit to operate at its highest efficiently. A grille, located in the base of the unit, must not be blocked at any time, or your unit will not perform as expected. ULIN_0093_A Initial Startup All U-Line units are shipped with controls that are preset. No initial adjustments are required.
Interior Lighting Temperature Display The LIGHT icon (Figure 3, 5) on the control panel is used to control an additional lighting function. The blackout/ Sabbath mode (not Star K certified) will turn the interior light and display (Figure 3, 3) off for a preset 36-hour period. To display the interior temperature: 1. Touch and hold the WARMER icon (Figure 5, 2) for approximately five seconds and release when the °F symbol in the display (Figure 5, 3) begins to flash. 2.
Normal Operating Sounds Outdoor, Marine and RV Usage All models incorporate rigid foam insulated cabinets to provide high thermal efficiency and maximum sound reduction for its internal working components. In spite of this technology, your model may make sounds that are unfamiliar. Some U-Line models are designed to operate in outdoor, marine and RV environments. For best performance, keep the unit out of direct sunlight. Normal operating sounds may be more noticeable because of the unit’s environment.
Maintenance 6 Cleaning and Maintenance Proper maintenance of your U-Line product will ensure efficiency, top performance and long life. The maintenance intervals listed are based on normal conditions. You may want to shorten the intervals if you have pets or other special considerations. General Cleaning Exterior Cleaning (As Required) Black and White Models: • Surfaces may be cleaned with a mild detergent and warm water solution. Do not use solvent-based or abrasive cleaners.
To defrost: CAUTION 1. Turn unit off. 2. Remove all products from the interior and prop the door in an open position (2 in. (5 cm) minimum). 3. Allow the frost to completely melt naturally. Clean the interior and all removed components using a mild nonabrasive detergent and warm water solution applied with a soft sponge or non-abrasive cloth. NOTE: DO NOT use any solvent-based or abrasive cleaners. They will discolor or damage the interior. 4.
Door Alignment Check and Adjustment IMPORTANT When properly aligned: 1 • The door will not be flush with the top of the cabinet. The top edge of the door will be 1/8 in. (3.175 mm) below the cabinet top. • The door gasket will be firmly in contact with the perimeter of the cabinet and not pinched on the hinge side of the door. The following procedure will correct for up to 1/4 in. misalignment: 2 3 ULIN_0201_A Figure 14 3. Turn the door upside down and inspect the hinge plate mounting holes.
Door Reversal 1 ULIN_0002_A Figure 18 2. Remove plastic screw plugs (three each, top and bottom) (Figure 18, 1) from new hinge location. Do not discard. 3. Remove top hinge (three screws) (Figure 17, 2) and reinstall hinge screw pin (Figure 17, 1). ULIN_0015_A Figure 16 Black and white units may be left- or right-hand opening. Stainless steel unit doors cannot be reversed. The doors are easily reversed by moving the hinge hardware to the opposite side.
5. Remove the two door closer inserts (Figure 20, 1) from the existing bottom hinge and install as shown on the new bottom hinge (Figure 19, 1). Door Shelf Removal/Insertion 6. Remove existing bottom hinge (three screws) and remount on opposite side TOP. Remove hinge screw pin. 1 7. Remove the plastic hole plug from the top of the door to allow the pivot pin to be inserted in the new location. Install the plug into the vacated hole on the opposite side.
Glass Shelf Removal/Installation Light Bulb Replacement Remove the shelves as follows: To replace the light bulb in your U-Line unit: 1 2 3 1 ULIN_0001_A 2 Figure 24 1. Grasp the edges of the light housing lens (Figure 24, 1) opposite the exposed tab and gently push the lens toward the tab (Figure 24, 2). ULIN_0066_A 2. Pull the edge of the lens down (Figure 24, 1) and swing it out of the light housing. Figure 23 1.
7 Service Before Calling for Service If your U-Line product appears to be malfunctioning, read through the OPERATION section of this guide to ensure that the function of all controls are clearly understood. If the malfunction persists, the TROUBLESHOOTING GUIDE in this guide will assist you in quickly identifying common problems, and provide information on possible causes and remedies. Most often, this will resolve the problem without the need to call for service.
Troubleshooting Guide NOTE: Recommended temperature setting is 38°F. DANGER ELECTROCUTION HAZARD Never attempt to repair or perform maintenance on the unit until the main electrical power has been disconnected. Troubleshooting - What to check when problems occur: PROBLEM POSSIBLE CAUSE REMEDY Unit does not operate and electronic display is blank. No electrical supply Plug unit in or check circuit breaker.
Electronic Control Quick Guide All Models Task Touch Turn ON/OFF Adjust Temperature Hold 10 seconds Touch Display Release when °F flashes. or or or Touch and release Touch to change temperature View Actual Temperature Hold 5 seconds Change °F-°C Hold Blackout Mode °F flashes after first touch, set-point saved after 5 seconds of inactivity and °F stops flashing.* For Wine Coolers, see Use and Care Manual. Release when °F flashes. Hold 10 seconds Comment or Repeat to switch back.
U-Line Corporation Limited Warranty U-Line Corporation warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, the evaporator, the hot gas bypass valve, the dryer and the connecting tubing) in each U-Line product to be free from defects in materials and workmanship for a period of five years from the date of purchase.
ULIN_016357_30090.fm Page 20 Wednesday, February 7, 2007 12:40 PM For General Inquiries: P.O. Box 245040 Milwaukee, Wisconsin 53224-9540 U.S.A. Phone (800) 779-2547 FAX (414) 354-5696 www.U-Line.com For Service and Parts Assistance: Phone (800) 779-2547 (414) 354-0300 FAX (414) 354-5696 Email: OnLineService@U-Line.com www.U-LineService.com E-mail: OnlineParts@u-line.
