Installation guide

www.U-LineService.com 6 07/2006
1115R and 1115WC Models
Reversing the Door
(1115R & 1115WC Black Units Only).
Black Model 1115R
To reverse the door, perform the following:
1. Remove the grille and grille cap (two screws).
2. Remove top hinge from cabinet (three screws) (Figure
4) . Hold door to keep it from falling.
3. Lift the door off the bottom hinge.
4. Remove bottom hinge from cabinet (two screws)
(Figure 5) .
5. Remove screws on opposite side of cabinet
(Figure 6) .
Note that there may be a nut behind one or both
screws on either side.
6. Install hinge on opposite side, bottom of cabinet
(Figure 7) . Replace nut on back side where installed.
Align hinge outer edge with cabinet before tightening
screws.
ULIN_0143_A
Figure 4
ULIN_0121 _
A
Figure 5
ULIN_0122 _
A
Figure 6
ULIN_0123 _
A
Figure 7
1
ULIN_0109_A
Figure 8