Owner Manual

USER GUIDE

Door Adjustments 2

u-line.com

SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE

3. Remove door by tilting forward and lifting door off

bottom hinge. Retain shoulder washers; they will

be reused.

4. Remove three screws from hinge holes on the opposite

side. Reinstall into holes where the hinge was

removed. Take care not to scratch cabinet.

Remove bottom hinge:

1. Remove bottom hinge from cabinet using 1/4” socket.

2. Remove corresponding screws on opposite side of

cabinet. On some models there may be a nut behind

one or both screws on either side.

Install bottom hinge:

Install two or three screws, depending on model. Replace

nuts if used.

Install top hinge and door:

1. Use alternate hinge supplied with unit and reinstall the

screws. Do not tighten..

2. Rotate door 180° to reverse and set the door onto the

bottom hinge.

3. Align flat edge of the hinge with the outer edge of the

unit.

4. Tighten three screws.

Align and adjust the door:

Align and adjust the door (see DOOR ALIGNMENT AND

ADJUSTMENT).

Install grille:

Install the grille.