User's Manual

For “Exclusion” from (removing from) a network: Put the Z-WaveTM Interface Controller
into “exclusion” mode, and following its instruction to delete the GR-309 from your
controller. Press the program switch of GR-309 for 1 second at least to be excluded.
!
!
!
!
!
For “Association”: Press the program of the GR-309 to get into the “Awake” mode, then
put the Z-WaveTM Interface Controller into “Association”, and following its instruction to
associate the GR-309 with other device. Hold on the program button GR-309 will get into
“Sleep” mode for power saving. Support one association group (5 nodes).
!
”Awake” mode: it is to leave the “Sleep” mode by Press the button, to allow the Z-
WaveTM Interface Controller to do “Inclusion”, “Exclusion”, “Association” and to reply and
receive the commands from controller.
6. Slide back the rear cover and screw fastening with the front cover, the LED should go
off.
!
!
Limited Warranty
Guarantees that every wireless door/window sensor is free from physical defects in
material and workmanship under normal use for one year from the date of purchase. If the
product proves defective during this one-year warranty period, U-Fairy will replace it free
of charge. U-Fairy does not issue any refunds. This warranty is extended to the original
end user purchase only and is not transferable. This warranty does not apply to : (1)
damage to units caused by accident, dropping or abuse in handling, or any negligent use;
(2) units which have been subject to unauthorized repair, taken apart, or otherwise
modified; (3) units not used in accordance with instruction; (4) damages exceeding the
cost of the product; (5) transit damage, initial installation costs, removal cost, or
reinstallation cost.
!
FCC ID: 2ACC6GR-309
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.