User Manual

Appendix • 199
Example Configurations using WAGO-I/O-CHECK
WAGO-I/O-SYSTEM 750
I/O Modules
6.5.1.2.2 Configuration of the Bluetooth
®
Master using "Net Forming"
1. Start WAGO-I/O-CHECK software (Version 3 or later).
2. Click on the [Identify] button.
Your node configuration is graphically displayed.
3. Click with the right mouse button on the Bluetooth
®
module that you
would like to configure as a slave.
4. Choose Settings in the context menu. This opens a new window for the
configuration of the module.
Attention
In order to perform the following steps, the Bluetooth module must retain all
factory settings (default settings); i.e, you have not yet attempted any con-
figuration. If this is not the case, click on the [Default], button to reset the
module's configuration.
5. Click on [Data Frame] in the toolbar.
6. Enter (if not already set) a process image size of 48 bytes and a mailbox
size of 12 bytes (see Figure 50).
Figure 50: Data Frame g064444e
7. Click on the [Read] button in the toolbar to update the view of the con-
figuration in the module.
8. In the list on the right side, assign the role of master to the module by
choosing "Master" under Device Role.
9. Choose the menu item Net Forming in the navigation bar.
The following section describes how to select the devices required to establish
a connection to the master. Devices that are visible for search requests can
first be searched for in a similar way to slave’s configuration (see Section
6.5.1.2.1, steps 9-12). They may also then be stored using "Drag & Drop" —
an example being dropping and dragging from the search results into the list
of authorized devices (slots 1…13). However, for safety reasons, WAGO de-